Browsing by Author "Bouchon, P."

Now showing 1 - 4 of 4
  • No Thumbnail Available
    Item
    In vivo postprandial bioavailability of interesterified-lipids in sodium-caseinate or chitosan based O/W emulsions
    (2015) Farfan, M.; Villalon, M. J.; Ortiz, M. E.; Nieto, S.; Bouchon, P.
    Recent studies have shown that it should be possible to control lipid bioavailability through food structural approaches. Nevertheless, the gastrointestinal-tract physiological conditions must also be considered. To get a better understanding of this phenomenon, we evaluated the effect of emulsification, as well as the use of sodium caseinate or chitosan, on the postprandial bioavailability of interesterified-lipids in O/W emulsions after oral gastric feeding Sprague-Dawley rats. We verified that emulsification may increase lipid absorption, as determined after feeding sodium-caseinate emulsions. However, this result could not be generalised. Interesterified-lipids that were emulsified with chitosan were equally absorbed as those contained in non-emulsified interesterified-lipids/distilled-water blends. (C) 2014 Published by Elsevier Ltd.
  • Thumbnail Image
    Item
    Rotary-moulded biscuits: Dough expansion, microstructure and sweetness perception as affected by sucrose:flour ratio and sucrose particle size
    (2021) Molina, M.T.; Vaz, S.M.; Leiva, Á.; Bouchon, P.
    Sucrose not only provides sweetness, but also modifies the thermal/viscoelastic behavior of dough during baking. Most research on biscuit manufacturing has been focused on sugar-snap and wire-cut biscuits, and there is a lack of accumulated knowledge with respect to rotary-moulded biscuits. The aim of this study was to analyze the effect of the sucrose:flour ratio and the particle size of sucrose on dough expansion and starch gelatinization during the baking of rotary-moulded biscuits, together with their link to sweetness perception. X-ray micro-CT and scanning electron microscopy were used to ascertain the link between sensory attributes and biscuit structural properties. Image analysis showed that biscuits with lower levels of sucrose resulted in a microstructure with smaller air pores and thinner walls, which may be related to a lower degree of grittiness and hardness at the first bite. Furthermore, the results revealed the partial gelatinization of starch in all formulations, along with a gelatinization degree that increased from 6 % to 40 % as the sucrose content decreased from 40 % to 10 % (d.b.). Interestingly, biscuits that were formulated with powdered sucrose at the highest concentration attained an expanded and non-collapsible structure, a behavior that could be linked to the low degree of starch gelatinization.
  • Thumbnail Image
    Item
    The creaming of short doughs and its impact on the quality attributes of rotary-molded biscuits
    (2021) Teresa Molina, M.; Vaz, S.M.; Bouchon, P.
    Scant attention has been given to understanding the impact of creaming stability on the final structure of semi-sweet biscuits, an aspect that has traditionally concerned the biscuit industry. Accordingly, the aim of this study was to analyze the influence of the creaming phase stability on the quality attributes of rotary-molded biscuits. Doughs were formulated with 10.2% of fat (wet basis) and 16.3% of sucrose (w.b.), using two sucrose particle sizes, which were either added directly or after dilution in water at different concentrations. Additionally, the creaming phase was prepared using either a low-shear or a high-shear mixer. The results show that an aqueous-phase migration occurred when the creaming was blended in a low-shear mixer, when using either powdered sucrose or granular sucrose diluted in water at a high concentration. The phase separation was inhibited with the high-shear mixer, which provided a stable creaming. Notwithstanding the variation in creaming stability, no differences were observed in hardness, aeration, sweetness, color and noise intensity. Additionally, the micro-CT analysis revealed that biscuits had a similar microstructure (air porosity and thickness of biscuit walls) when they were prepared with either an unstable or a stable creaming phase. Consequently, creaming stability does not seem to affect the structure and the most relevant sensory attributes of rotary-molded biscuits under this set of experimental conditions, which are representative of those used by the industry for this product category.
  • Thumbnail Image
    Item
    The effect of arabinoxylan and wheat bran incorporation on dough rheology and thermal processing of rotary-moulded biscuits
    (2021) Molina, M.T.; Lamothe, L.; Gunes, D.Z.; Vaz, S.M.; Bouchon, P.
    Wheat bran incorporation into biscuits may increase their nutritional value, however, it may affect dough rheology and baking performance, due to the effect of bran particles on dough structure and an increase in water absorption. This study analyzed the enrichment effect of wheat bran and arabinoxylans, the most important non-starch polysaccharides found in whole wheat flour, on dough rheology and thermal behaviour during processing of rotary-moulded biscuits. The objective was to understand the contribution of arabinoxylans during biscuit-making and their impact when incorporated as wheat bran. Refined flour was replaced at 25, 50, 75, or 100% by whole flour with different bran particle sizes (fine: 4% > 500 mu m; coarse: 72% > 500 mu m). The isolated effect of arabinoxylans was examined by preparing model flours, where refined flour was enriched with water-extractable and water-unextractable arabinoxylans. Wheat bran had the greatest impact on dough firmness and arabinoxylans had the greatest impact on the elastic response. The degree of starch gelatinization increased from 24 to 36% in biscuits enriched with arabinoxylans or whole flour and coarse bran. The microstructural analysis (SEM, micro-CT) suggested that fibre micropores may retain water inside their capillaries which can be released in a controlled manner during baking.